Available Drivers
-
plextor
- Supports CD structure analysis (command
read-toc) for Plextor CD-ROM readers. Pre-gaps
and index marks are detected by performing a binary search
over the Q sub-channel for each track. This method is fast
and gives very exact results on Plextor drives. The driver
uses generic SCSI commands (PLAY AUDIO and READ SUB-CHANNEL)
so it may work on other models,
too, but result and speed is directly correlated to the
digital audio extraction capabilities.
-
plextor-scan
- This is an alternate driver for CD structure analysis with
Plextor drives. It scans the Q sub-channels of a track
linearly like the
generic-mmc driver but is
faster on Plextor drives.
-
cdd2600
- This is a native driver for the Philips CDD2000/CDD2600
drive family.
read-toc is implemented like in
the plextor driver but it is slow and not very
exact due to poor digital audio extraction capabilities of
these drives. Anyway, I don't recommend doing CD structure
analysis with the CDD2x00 because it stresses the mechanism
too much.
generic-mmc- This is a driver for SCSI-3/mmc compatible CD-recorders
that support session-at-once (cue sheet based) writing. Most
of the recent drives should be compatible with this
or with the
generic-mmc-raw driver described
below.
CD-TEXT writing is supported with CD-TEXT capable
recorders.
read-toc scans linearly the Q sub-channel of
each track to retrieve the pre-gap length and index
marks. This method is very accurate but takes the same time
like digital audio extraction. It should also work with
recent CD-ROM readers.
generic-mmc-raw- This is an alternate driver for SCSI-3/mmc compatible
CD-recorders. It uses the raw writing interface where the
driver has to provide the PQ sub-channel data in addition to
the audio data. This writing mode allows using part of the
lead-out area for audio data since the drive's firmware
has no chance to prevent this. Of course, you will get some
error message at the end of writing when the CD-R capacity
is exhausted.
CD structure analysis is done like in the
generic-mmc driver.
ricoh-mp6200- Supports writing with the Ricoh MP6200S CD recorder. It
cannot write the Catalog Number, yet.
CD structure analysis is done like in the
generic-mmc driver.
sony-cdu920- Driver for the Sony CDU920 recorder. Audio and data
tracks are supported. The Sony CDU948 recorder will work
with this driver, too. Use option
--speed 0 to
get the full writing speed.
read-toc uses the Q sub-channel scanning method.
sony-cdu948- Driver for the Sony CDU948 recorder. It extends the
sony-cdu920 driver by CD-TEXT writing and multi
session mode.
taiyo-yuden- This is an adapted
cdd2600 driver for
Taiyo-Yuden recorders. 'read-toc' is done with the
plextor method.
teac-cdr55- Driver for the Teac CD-R55 recorder. Audio and data
tracks are supported.
read-toc uses the Q
sub-channel scanning method.
yamaha-cdr10x- Driver for the Yamaha CDR10X recorder series that supports
audio and data tracks.
read-toc uses the Q sub-channel
scanning method.
Last update: Sep/15/2002
|
Home
GCDMaster Home
News
Application Examples
Available Drivers
Supported Drives
Download
Changelog
|